Black Hawk Labs 4U + 2U Standard MiniRaQ Spécifications télécharger pdf (Page 5)

www.miniraq.com

PAGE 5

An approved hollow wall application is considered to be either of the following;

Cinder Block wall or NEC type 3/4” plywood electrical panel backing using

toggle bolts is safe for full rated load of MiniRaQ System.

In the event that this bracket is to be mounted on a block wall 1/4” x 3” toggle

bolts should be used to support it. It will be important that the hollow pocket

in the block is located so that the toggle can open properly to support the

weight. Toggle bolt clearance hole is 1/2” (bolts and washers not supplied;

available for purchase separately).

(TM)

Mounting to Cinder Block or Approved Hollow Wall (Hole Pattern C)

Place the MiniRaQ main back panel against the wall in the preferred location.

Using integrated level, adjust panel to level thenmark a of the two

top and two bottom ½ inch clearance holes (Hole C). Drill marked holes and apply

Togglers® or other associated inserts as required. Lift main back panel and hand

tighten bolts and fender washers (not supplied) most of the way into stud.

Tighten all screws.

Next go to bracket installation details .

(TM)

minimum

(pg 7)

Note

This Illustration shows recommended

mounting pattern for concrete screws

with fender washers

FIGURE 5

1 2 3 4 5 6 7 8 9 10

Pas de commentaire

Black Hawk Labs 4U + 2U Standard MiniRaQ Spécifications Page 5