Black Hawk Labs 4U + 2U Standard MiniRaQ Spécifications télécharger pdf (Page 6)

www.miniraq.com

PAGE 6

Mounting to Concrete Wall with TAPCON® bolts

(Hole Pattern C)

Place the MiniRaQ main back panel against the wall in the preferred location.

Refer to Figure 5 on Page 5 for correct mounting hole pattern.

Using integrated level, adjust panel and to level and mark a of the two top,

two bottom and two middle 1/2” clearance holes (Hole C) Drill 5/32” pilot holes

for 3/16” bolts, or 3/16” for 1/4” bolts pilot holes as required by manufacturer.

Apply TAPCON® or equivalent concrete double threaded screws. A minimum

2 1/4” length is recommended for full rated loading of MiniRaQ.

Lift main back panel and hand tighten bolts and washers (not supplied) most of

the way into wall. Tighten all screws.

Next go to bracket installation details (pg 7).

(TM)

minimum

Mounting to Concrete Wall with Compression Lags (Hole Pattern C)

Place the MiniRaQ main back panel against the wall in the preferred location.

Refer to Figure 5 on Page 5 for correct mounting hole pattern.

Using integrated level, adjust panel and to level and mark a of the

two top and two bottom ½ inch clearance holes (Hole C) Drill marked holes as

required and apply compression studs or other associated inserts as required.

Lift main back panel and hand tighten bolts and fender washers (not supplied)

most of the way into stud. Tighten all screws.

Next go to bracket installation details .

(TM)

minimum

(pg 7)

Warning

The MiniRaQ must be properly installed to a suitable surface and using

recommended hardware per instructions provided.

Caution:

(TM)

1 2 3 4 5 6 7 8 9 10

Pas de commentaire

Black Hawk Labs 4U + 2U Standard MiniRaQ Spécifications Page 6